Toilet Paper Snowman
A snowman made out of toilet paper and a plunger
Yield: 1
Cost: $10
Materials
- 4 rolls toilet paper
- 1 roll cellophane
- 1 18 inch. plunger
- 1 twist tie
- 1 sheet vinyl adhesive black
- 1 set snowman face decals
- 1 winter cap or beanie
Instructions
- Place your plunger on top of your work surface
- Place toilet paper rolls over the plunger pole - I used 4 rolls. The top toilet paper roll should cover the pole or mostly cover it.
- Cut the cellophane wrapper so that it fully wraps around the toilet paper rolls and can be taped to seal it.
- Seal the wrapping paper with clear tape.
- Pull the top of the cellophane wrapper together and use a twist tie to secure it.
- Using the black vinyl adhesive, cut out your snowman's boots. Mine are 3 inches tall by 3 inches wide. Adjust yours so that it fits your bottom roll of toilet paper.
- Using the same vinyl adhesive, cut the 3 buttons. I cut mine about 1 inch in diameter.
- Place the boots and buttons on your bottom rolls - leaving the top alone for the snowman's face
- Use the adhesive snowman face sticker to create a face on the top toilet paper roll
- Add your hat to the top - If you feel like you need to, tape the hat to secure it
Notes
cost and time are only estimatesÂ